PB-DA-2Y（A.B.C.D）系列壓力變送器

• 用途

I Functions

PB-DA-2Y系列產品利用技術與德國Analog Microectcsco.,Ltd公司合作開發的新型壓力變送器，采用精密光刻箔式電阻應變計及德國AMG公司生產的變送器用集成電路。它設計新穎*，工藝*，信號輸出穩定，優良的性能價格比，是遠傳壓力表的理想替代產品。它可廣泛應用于冶金、電力、自來水、化工和石油等工業現場，實現遠程監控和控制。

With the patented technology and developed in cooperation with German Analog Microectcsco., Ltd, PB-DA-2Y Series products as new pressure transmitters adopt precision lithography foil resistance strain gauge, and dedicated transmitter-use integrated circuits from AMG. They are featured with unique design, advanced manufacturing technology, stable output signals and cost-effective figures. It is a kind of ideal alternative for transmissible pressure gauge and can be widely used in metallurgy, electronics, tap-water, chemical and oil industries, which can realize remote monitoring and network control.

• 技術參數

II Technical Parameters

1. 信號輸出精度：1.0 級

The accuracy of signal outputs: 1.0 degree

1. 表面指示精度：1.6 級

2. The accuracy of surface indicator: 16 degree

3.量程：-0.1—0.3Mpa 0～0.4Mpa 0～0.6Mpa  0～1.0Mpa 

0～1.6Mpa 0～2.5Mpa 0～4.0Mpa  0～6.0Mpa

     3. Measuring Range:

 4.信號輸出：4-20mA / 0-20mA / 0-10mA / 0-5V/1-5V

     4. Signal Outputs:

5.工作電壓：24V DC    負載電阻：1.2KΩ(標準24V/DC電源)

5. Operating Voltage:24V DC  Load Resistance: 1.2KΩ(Standard 24V/DC Power Outlet)

6.傳輸方式：二線制數字化智能       三線制

6. Transmission Mode: two-wire digital inligence   three-wire system

7.接頭螺紋：ZG1/2       M20x1.5

7. Connection Thread

8.使用溫度：-20~45℃

8. Operating Temperature

9.防護等級：IP30

9. Protection Grade

三、使用須知

III Notice of Use

1. 儀表適用于測量各類液體、氣體及其它流體壓力。上限不應超過3/4，測量波動壓力時上限不應超過2/3，zui低壓力在兩種情況下都不低于上限的1/3。

1. The instrument can be applicable to measure various types of liquid, gaseous, or other fluid pressure. Upper limit should not be exceeded to 3/4, when it applies to measure surge pressure, upper limit should not be exceeded to 2/3, and minimal pressure should be not less than 1/3 of the upper limit in both of two situations.

2.露天安裝時，都應加遮雨裝置

2. Rainproof set is necessary in open-air installation

3.儀表出廠時已加裝了阻尼螺釘. 不要拆除。但被測介質急劇沖擊震動時應加裝相的YFN-01阻尼抗震器(選件)

   3. All instruments are factory equipped with a damping screw, please do not remove it. When measured medium vibrates fiercely, YFN-01 suppressing vibration damper should be added to install. (Option Item)

4.為了儀表的安全，儀表供電應加裝SAB-99電力線路避雷器及電涌抑制器(選件)。

4. For the instrument safety, the power supply should install SAB-99

Power line lightning arrester and surge suppressor. (Option Item)

5.儀表應裝在和測量點同一水平線上，環境溫度為0℃～+45℃，相對濕度不大于80%場合使用。當環境溫度為-20℃～+85℃時儀表也可工作，但測量精度有所下降。超過85℃應配加T1散熱器(選件)。

5.The instrument should be installed in line with the measurement point, which requires the environmental temperature is from 0℃～+45℃, and the relative humidity is not more than 80%. Under the range of -20℃～+85℃, instrument works but the accuracy decreases. T1 dedicated radiator should be installed when environmental temperature is above 85℃. (Option item)

6.儀表用直流電源DC:20V～24V、交流紋波＜5mV單臺儀表按1.2W/24V～50mA計算

6. DC power for instrument use: DC:20V～24V  AC Ripple＜5mV for each instrument 1.2W/24V～50mA

7.儀表供電必須正確，直流供電不能反接。

7. The power supply should be connected correctly, DC cannot be reversed connected.

8.不要自行拆卸儀表，人為造成的儀表損壞、雷擊及電涌和過電壓造成的儀表損壞、急劇的機械震動和水錘沖擊造成的儀表損壞不屬保修范圍。

 8. Do not repair or disassemble the instrument by yourself, damages caused by human error, lightening, electrophoresis and overvoltage, sharp mechanical vibration and water hammer , do not belong to the warranty scope.

四、接線方法

IV Connection Method

1. 三線制電纜輸出色標：

Three-wire output color code:

紅色：+電源（+V ） 黑色：公共地線 （GND）     黃色：輸出信號+（OUT）

Red: + power    Black: Ground Wire      Yellow: Output Signal

三線制德國激勵防水接頭信號輸出:

Signal Outputs of the three-wire German Inspire waterproof connectors

接頭1：+電源（+V ）  接頭2：輸出信號+（OUT） 接頭3：公共地線 （GND）

Connector 1: + power    Connector 2: Output Signal   Connector 3: Ground Wire

2.二線制4-20毫安電纜線                紅色為 +電源   黃色為信號+

 Two-wire 4-20Ah Cable           Red:+ Power  Yellow: Signal

二線制4-20毫安航空插座              信號輸出1+電源   2為信號+

 Two-wire 4-20Ah Aerial Socket     Signal Outputs 1:+Power  2: Signal

二線制4-20毫安德國激勵防水接頭      信號輸出1+電源   2為信號+

Two-wire German Inspire waterproof connectors  Signal Outputs 1:+Power  2: Signal

五、電源與負載特性 （圖1）

V Power Supply and Load Characteristic

工作區（Working Area）

六.訂貨須知

VI Ordering Information

1.PB-DA-2Y(A)變頻器配套         外殼材質304      部件96黃銅

  Special affiliated to frequency converter   Shell Material 304    unit 96 copper

1. PB-DA-2Y(B)用于測量有腐蝕介質壓力 外殼材質304  部件316L不銹鋼

 Apply to measure the pressure of the mordant medium   Shell Material 304    unit 96 Stainless steel

3.PB-DA-2Y(C)用于測量真空及負壓     外殼材質304  部件316L不銹鋼

Apply to measure vacuum pressure and negative pressure   Shell Material 304    unit 96 Stainless steel

4.PB-DA-2Y(D)有輔助電接點輸出       外殼材質30碳鋼   部件96黃銅

For output with the extra electric contact  Shell Material 30 carbon steel    unit 96 copper

5.通常供貨為徑向，軸向須訂貨時特別說明

Radial Direction will be ordered generally, unless axial direction is specified in order placing.